Will the Redarc Tow-Pro Elite Work with the HydraStar Electric Over Hydraulic Actuator

Question

Question:

I have a Hydrastar HBA 1200 series Gen7 is the Redarc to work v2 compatible?

asked by: Adam

0

Expert Reply:

Yes, the Redarc Tow-Pro Elite Trailer Brake Controller part # RED44FR will work with your HydraStar Electric Over Hydraulic Actuator for Drum Brakes part # HBA-12.

expert reply by: Conner L

0

click to enlarge

Answer 1

To add a brake controller to your 2022 Chevy Silverado 3500 you are going to want the Redarc Tow-Pro Elite Brake Controller item #RED63RR. This brake controller has a unique installation method where you can mount the control knob on your dash or…

view full answer...

Answer 2

To connect the Redarc Tow-Pro Elite item #RED63RR to your 2003 H2 you will need the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers item #3015-P. This harness plugs directly into the Redarc wiring adapter that comes with item…

view full answer...

Answer 3

I spoke with my colleague who has done extensive research on the electric over hydraulic actuators and factory brake controllers. He stated that the integrated brake controller in a 2011 Dodge Ram will work fine with the Carlisle Hydrastar,…

view full answer...

Answer 4

Yes, the Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR is compatible with the Hydrastar Electric Over Hydraulic Actuator for Drum Brakes #HBA-12.

view full answer...

Answer 5

It sounds like you have an older generation of the Carlisle Hydrastar brake actuatuator. The current #HBA-CAM would only be compatible with 6th generation and newer actuators. It wouldn't be a compatible replacement for your 381-7061. The…

view full answer...

Answer 6

Yes, the Hydrastar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness item #HS381-9065 will work with the Redarc Tow-Pro Elite Trailer Brake Controller item #RED44FR. The Tow-Pro Elite works with electric over hydraulic…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 12

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Will the Redarc Tow-Pro Elite Work with the HydraStar Electric Over Hydraulic Actuator

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching