Mounting Bolt Holes of Titan Coupler
Question:
Why is it that we cant use the drilled holes on the top side of the coupler for mounting holes? Also, one of the Youtube guys mentioned that we aren't supposed to weld to truck frame flanges, the top and bottom of the C-channel that is the frame. Just curious.
asked by: Billy B
Expert Reply:
You can absolutely use the holes on the top of the Titan Zinc-Plated, Leverlock Coupler # T4845000 as holes to bolt on the coupler; in fact that is their exact purpose. I'm not sure which video you were watching specifically, but this is not a weld-on coupler due to its zinc plating which can be more difficult to weld.
I have added a link to a video review of this coupler or you to check out.
Product Page this Question was Asked From
Dexter Zinc-Plated, Leverlock Coupler - 2" Ball - 3" Channel - Bolt On - 5,000 lbs
- Straight Tongue Trailer Coupler
- Standard Coupler
- 2 Inch Ball Coupler
- Bolt-On
- 5000 lbs GTW
- 3 Inch Channel
- Trigger Latch
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Surge Brake Actuator Repair for Titan Drum Brake Actuating Coupler
- Q&A: Recommended Coupler for Boat Trailer With 3" Wide Channel
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Information Is Needed To Find a Replacement Surge Brake For a Obsolete Atwood?
- Q&A: Mounting Bolt Hole Dimensions of Dexter DX7.5L A-60 Brake Actuator For Disc Brakes
- Q&A: How Does the Bolt Pattern on the Demco DM12717 Coupler Measure?
- Q&A: Replacement Master Cylinder for a UFP A-60/A-75 Surge Brake Actuator
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Where to Position the Trailer Axle?
- Q&A: Can I Weld on a Bolt on Brake Actuator?
- Article: What Is A Leaf Spring? (Everything You Need to Know About Trailer Leaf Suspension)
- Article: How to Replace Trailer Leaf Springs in 5 Steps