Replacement Motor for SCS/Frigate 202-3230 on Coach Step

Question

Question:

I have a Scs/frigate 202-3230 do you have one or what is the replacement

asked by: Kenneth A

0

Expert Reply:

I reached out to my contact at Lippert who said you have a Coach Step and your replacement motor is part # LC301702.

expert reply by: Jon G

0

Answer 1

The correct replacement control model for the SCS/Frigette Coach Step Controller part 202-3230 is the Replacement Control Module for Lippert Electric Coach Step part #LC301702.

view full answer...

Answer 2

Both of these manufacturers make excellent products and both products have received excellent customer reviews. The main difference is that the Kodiac Disc Brake Kit and Titan BrakeRite Electric-Hydraulic Actuator, #T4843800, which you referenced,…

view full answer...

Answer 3

That is a strange issue to have. The issue may be with one of a few parts. It could be that the motor is stuttering before the steps are fully retracted causing them to retract as it thinks that it may be hitting something. The controller may be…

view full answer...

Answer 4

The Replacement Control Module for Lippert Electric Coach Step #LC301702 has the purple wire that connects to the door light switch. The other end of the switch #LC301694 connects to the Replacement Wiring Harness for Lippert Electric Coach Step…

view full answer...

Answer 5

If you check out the diagram I attached you will see how the steps should get wired up. What I would first do is verify that you have voltage in all of the right places on your steps to determine if the module needs to be replaced with the #LC301702.…

view full answer...

Answer 6

The replacement control module that you need for your 202-3207 control module on your Coach Steps is the Lippert part #LC301702 on our site. I reached out to my contact at Lippert who said this control module is the correct replacement for all of the…

view full answer...

Answer 7

The issue you described sounds like a faulty control module. In order to replace this you will want to use the Replacement Control Module for Lippert Electric Coach Step part #LC301702 which is a direct fit for your Lippert Steps 128980. I spoke with…

view full answer...

Answer 8

Generally replacing the Magnetic Sensor is not required when replacing the Replacement Control Module for Lippert Electric Coach Step part #LC301702. Since it is an exact replacement part the magnetic sensor will trigger the switch as it has on your…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Motor for SCS/Frigate 202-3230 on Coach Step

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching