How Long Is the Pollak Metal 7-Pole, RV-Style Trailer Connector Part # PK12702
Question:
How long is this part? My standard Reese 7-pin connector interferes with my weight stabilizer bar, which is plugged into the power module on my trailers frame. If I had a shorter 7-pin I could use my stabiliser bars again. Thanks!
asked by: Stewart G
Helpful Expert Reply:
The Pollak Metal 7-Pole, RV-Style Trailer Connector part # PK12702 is 2-3/4" long from the face to the rubber boot on the back. This is currently the shortest trailer connector we offer so if you still do not have enough room you might want to consider moving the frame bracket for the weight distribution system just a bit. The frame brackets usually have a range that they can be installed in rather than a set point anyhow.
Product Page this Question was Asked From
Pollak Metal 7-Pole, RV-Style Trailer Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 7 Round - Blade
- Pollak
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Motor For Lippert Ground Control Leveling System On 2018 Keystone Laredo Travel Trailer
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting Brake Controller Installations
- Q&A: Can Brakes be Added to Second Axle in Tandem Axle Setup
- Q&A: Wire Gauge to Use With Epicord 7-Way Molded Trailer Plug
- Q&A: Replacement Parts for Dexter Motorhome Axle 8-133
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Replacement Breakaway Cable and Plunger for a 2022 Lance Travel Trailer
- Q&A: Replacing the Breakaway Brakes Pin When It Becomes Disconnected From The Breakaway Switch
- Q&A: How to Choose New Axle For Standard Hub
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Routing the Power Wire for a Trailer Wiring Harness