Does Derale Stacked Plate Oil Cooler Kit # D15602 Come with Thermostat Bypass

Question

Question:

Does this have a thermostat and bypass so not to overcool the engine oil? Does the oil filter still screw on to the sandwich adapter?

asked by: Robert

0

Expert Reply:

Yes, the Derale Stacked-Plate Engine Oil Cooler Kit # D15602 that you referenced does have a thermostatic bypass that prevents oil cooler than 180 degrees from going through the cooler which allows the engine to warm up quickly but then stay cooler once operating temperatures have been reached.

The oil filter then does attach to the sandwich adapter.

expert reply by: Jameson C

0

Answer 1

There are three basic types of heat exchangers. Tube and fin, plate and fin and stacked plate. Stacked plate being the most efficient. Take a look at the informative article about oil coolers I included. The cooler I recommend is the Derale stacked…

view full answer...

Answer 2

Generally speaking, the best oil/transmission cooler to use would be the largest one you have space available for in front of the radiator/condenser behind the grill of your 2009 Chevy Silverado 1500. Therefore, as long as you have 13" wide x…

view full answer...

Answer 3

Yes, you can use Derale Oil Cooler kit #D15602 in your FJ Cruiser. A supplementary oil cooler like the Derale #D15602 is a great way to keep your engine oil temperature in the ideal 180 to 200-degree Fahrenheit range. This Class III cooler kit…

view full answer...

Answer 4

The difference between the Derale Stacked-Plate Engine Oil Cooler Kit part #D15602 and part #D15605 is that the former comes with a 2-3/4" o-ring and the latter comes with both a 2-3/4" o-ring and a 3-1/2" o-ring. These o-rings are…

view full answer...

Answer 5

The Derale Stacked-Plate Engine Oil Cooler #D15602 can basically be installed in any orientation. It does not have to face a certain direction to function properly as the oil will make its way to the other side of the cooler regardless of how it is…

view full answer...

Answer 6

Yes. According to the installation instructions, you need to use the included thread sealant tape to install the two 3/8” NPT x 1/2” hose barbs into the sandwich adapter of the Derale Engine Oil Cooler #D15602. If you need sealant tape, I recommend…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Does Derale Stacked Plate Oil Cooler Kit # D15602 Come with Thermostat Bypass

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching