Is A Bit Of Play In The Adjustable Shank and Head Assembly Normal With Curt C17062
Question:
I recently bought a 2016 F150 with the factory towing package. My question has to do with play in the shank. When I slide the Curt adjustable ball mount shank from the Round Bar Distribution Hitch kit 17062 into the trucks receiver, I notice play up and down and side to side. I also noticed, I have play between the ball mount head assembly and the adjustable shank of the distribution hitch. Is play acceptable in either the receiver or the ball mount head assembly? Could something be wrong with the adjustable shank? If play is acceptable, how much. If not any suggestions for a remedy. Thank you.
asked by: Bob
Expert Reply:
I contacted the tech at Curt regarding the play in the adjustable shank of your Curt MV Weight Distribution System part # C17062 and he said a little bit of play or tolerance is completely normal. The same goes for the ball assembly on the adjustable shank. As long as the bolts are properly inserted you have nothing to worry about.
To help with the annoying rattle noise you can use a Roadmaster Quiet Hitch part # RM-061 to tighten up the slack. When you use the Quiet Hitch with a weight distribution system you position the U-bolt around the top of the hitch receiver and place the bar on the bottom of the weight distribution shank. Basically the opposite of the original instructions. I have attached a photo for reference except the U-bolt will be upside down on your setup.
Products Referenced in This Question
Roadmaster Quiet Hitch for 2" Trailer Hitches
- Hitch Anti-Rattle
- Standard Anti-Rattle
- Universal
- Fits 2 Inch Hitch
- Sleeve Style
- Accessory Anti-Rattle
- Towing Anti-Rattle
- Roadmaster
more information >
Product Page this Question was Asked From
Curt MV Weight Distribution System w/ Friction Sway Control - Round Bar - 10K GTW, 1K TW
- Weight Distribution Hitch
- WD With Sway Control
- Some Sway
- Includes Shank
- Electric Brake Compatible
- Fits 2 Inch Hitch
- Does Not Allow Backing Up
- 900 lbs
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: LED Trailer Taillight Recommendation for a 3110 Feather Lite Car Trailer
- Q&A: Replacement for Kwikee Revolution Step 9010000464 on 2011 Winnebago Journey 40U
- Q&A: Replacing Trailer Actuator Buddy 32220 Reverse Solenoid on Triton Bass Boat Trailer
- Q&A: What Are the Thread Sizes of the Orifice Connector for Trailer Brake Actuators
- Q&A: Troubleshooting No Power at the Tail Light Pin on a 2007 Toyota FJ Cruiser
- Article: Determining Trailer Tongue Weight
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: Converting From 7-Way Round to 7-Way Flat Connector
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Article: Will Flat Towing Blow Up Your Transmission?
- Article: Which Sway Control Hitch is Right For Your Trailer?