Troubleshooting Right Rear Lippert Ground Control Jack Moving Small Amounts

Question:

hi the right rear jack will only move for a second or two then stops till i hit down on it again does the same going up so it shows a error any suggestions

asked by: ROBERT G

Expert Reply:

The RR error code on your Lippert Ground Control # LC358590 is one of the errors listed in the manual, and it states to check harness connections at controller and at jack, check harness for damage and repair or replace as necessary. Normally to clear a code like this you have to extend the jacks 6 inches before retracting.

Since you still seem to be having an issue with the jack moving a small amount. I suggest pressing the retract button and the enter button simultaneously holding for about 3 seconds and it will clear the error code. It may function fine after that, but if not, you probably need to have it looked at.

For a replacement right rear jack you'd need the part # LC344792.

expert reply by: Jameson C