How To Run a 12 Volt Power Wire for the 7-Way on a 2008 Chevrolet Silverado
Question:
Fuses are good ... red wire is hooked up to stud 1 ... 12 v is showing when I test the red wire at the stud ... shorts out or becomes non existent when checked from the trailer plug ... if I ran a new wire what color w wire would I splice into in order to have it run to the proper prince in the 7 way connector top right +
asked by: Branden
Expert Reply:
The 12 volt power wire that goes from the power distribution center to your 7-way trailer connector should be a red/black wire but so long as you are splicing into the one that is ran to to the correct terminal (see photo) then color will not matter. Once you have this wire you will need to cut it in two, splice the end from the connector onto part # 10-1-1 (per foot) with part # 224775 and then run this wire up to the power distribution center stud with part # 185917 and part # DW05705-1.
Products Referenced in This Question
Zinc Plated Hex Flange Nut - M8
- Accessories and Parts
- Trailer Brake Controller
- Hardware
- Nuts
- Hex Nut
- Flint Hill Goods
more information >
Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 1
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Spectro
more information >
Ring Terminal - 12-10 Gauge Wire - 3/8" Ring ID
- Wiring
- Wire Connectors
- Ring Terminals
- 3/8 Inch Diameter
- 12-10 Gauge
- Deka
more information >
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Tow Wiring for a 2023 Kia Telluride With LED Lights
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Q&A: Can Electric Brakes be Used on a Boat Trailer
- Article: Brake Controller Installation for 2007 (New Body Style) - 2013 GMC Sierra and Chevy Silverado
- Q&A: How to Charge a Trailer Battery Through a 7-Way Connector
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: What Gauge Wire Is Needed To Run Charge Line for Battery From Truck to Trailer
- Q&A: What is the Proper Gauge Wire for Installation of a Brake Controller and Trailer Brakes
- Q&A: How to Tell if Dexter Axle 3,500 lb Electric Trailer Brakes Will Fit Axle