Replacement Hydraulic Brakes for a 2000 Jayco Eagle UDST Pop-Up Camper

Question:

I need to replace the hydraulic trailer brakes, as well as the hub/drum assemblies races/bearings included, on my 2000 Jayco Eagle UDST PUP. The bolt pattern is 5 on 4.5. It appears that the brakes are 10. Picture attached. I recently replaced the brake actuator that your people recommended, 8605001 with DM11993 . Thanks in advance,

asked by: Tony

Expert Reply:

The correct braking assembly for your 2000 Jayco Eagle UDST Pop-Up Camper is most likely the Hydraulic Trailer Brake Kit part # AKUBRK-35 which is 10" x 2-1/4" but if you take a quick measurement of the contact surface inside your drum you should be able to confirm this.

The correct hub/drum assembly for your 2000 Jayco Eagle UDST Pop-Up Camper will be a bit more difficult to find because there are a few different options depending on axle capacity. In order to confirm this I would need the serial number off the axle tag which is located in the center of the axle. However, based on the braking assembly dimensions and bolt pattern that you provided it would appear that you need the Trailer Hub and Drum Assembly part # AKHD-545-35-K. If you measure where the inner/outer bearing ride on the spindle and they are 1.378" and 1.063" respectively then you can use the above.

expert reply by: Conner L