Trailer Hitch for 4 Inch Square Bumper
Question:
I recently purchased a bumper mount hitch. I have a 4 inch bumper. The hitch is a little too small to fit on the bumper. any ideas on how to get it to go on? It measures just 3 and 7/8 on the outside. at the base it is closer to 4 inches.
asked by: Gary
Expert Reply:
If the bumper mount hitch you purchased is too small for your 4 inch bumper then there's really no way to securely mount it without modifying either the hitch or your bumper, which I don't recommend. Installing the hitch in any way other than what's intended will likely reduce its capacity to an unknown number since it's not been tested in that manner which could lead to damage.
A much better option is going to be with a hitch like the Curt # E-100 that's specifically designed to attach to a 4 inch square bumper like what you have. This uses the included hardware to simply mount around the bumper to provide you with a 2 inch receiver with a 350 pound tongue weight capacity and a 3,500 pound towing weight limit. If you are planning on using the hitch for non-trailer loads (bike racks, cargo carriers, etc) then Curt does require the use of a stabilizing strap # 18050.
I have attached a short video demonstration on this hitch that you can check out as well.
Products Referenced in This Question
Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1
- Accessories and Parts
- Hitch Bike Racks
- Hitch Cargo Carrier
- Tie Down Straps
- CURT
more information >
Product Page this Question was Asked From
Curt RV Bumper 2" Trailer Hitch Receiver
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Hitch Receiver do You Recommend for My 2022 Grand Design Imagine 2600RB Travel Trailer?
- Q&A: Recommended Slide Out Topper For A 138-1/2" Flange To Flange Measurement
- Q&A: Comparing Patriot Slider and Companion Slider Fifth Wheel Hitch for 2017 Ford F-350
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Article: Best Bike Racks for Electric Bikes
- Q&A: How Much Does the Kuat Transfer V2 Weigh?
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: What Is the Wire Size On the Go Power RV SAE Port for Portable Solar Panels
- Q&A: Recommended Hitch for a 2018 Grand Design Solitude 5th Wheel