How Does Cable Separate from RV Waste Valve

Question

Question:

how to seperate cable from valve?

asked by: Larry B

0

Expert Reply:

Take a look at the picture I have included. You can see that the cable is secured to the valve using a set screw. So you would loosen that, pull out the old cable, put in the new one, and tighten the set screw back down. If your valve is set up the same way then it can be done.

expert reply by: Jameson C

0

click to enlarge

Answer 1

We actually sell a version of the LaSalle Bristol Cable-Actuated RV Waste Valve for Gray Water Tank #34466N11AB72GMA that you referenced in a 48 inch long cable version as part #34466N11AB48GMA. I would not recommend attempting to shorten the cable…

view full answer...

Answer 2

I contacted Jayco on what flush valves and cable lengths you have on your 2019 Jayco North Point Fifth Wheel. Your black water valve cable is 60" cable which we only offer in a 72". LaSalle Bristol Cable-Actuated RV Waste Valve - Black…

view full answer...

Answer 3

LaSalle Bristol makes a waste valve similar to the #34466N4AB36GM which has a 120 inch long cable as part number #34466N4AB120GM. 120 inches is 10 feet which is as close as we can get to the size you are looking for. The measurement is from the base…

view full answer...

Answer 4

We have several replacement valve options for RV gray water, 1-1/2" all in black, such as the Bristol Waste Valve for RV Gray Water Tank - 1-1/2" Diameter - Hub to Spigot Item #34466N11AB or the #34466N11AB72GMA with a 72" cable. So…

view full answer...

Answer 5

I checked with LaSalle Bristol and they don't offer just the replacement cable. If the cable is broke you will need to replace the entire waste valve for which we offer part #34466N4AB48GMA for black water or part #34466N11AB48GMA for gray water.…

view full answer...

Answer 6

There unfortunately isn't a guide that tells us the length of the cables that were used in your Winnebago so you would have to trace the cables to determine the correct length needed. From Valterra we only have the 72" length, which you were…

view full answer...

Answer 7

The LaSalle Bristol Cable-Actuated RV Waste Valve #34466N11AB72GMA is going to have a 72" long cable. This will allow you to open and close the valve even if it's in a hard-to-reach place. The shortest that this comes is the LaSalle Bristol…

view full answer...

Answer 8

The abs cement isn't going to come loose and will require you to cut the pipe a bit further back and using a coupling #D50-2935 and more straight pipe to get back to where it originally sat for the valve. That being said, you can also just unbolt…

view full answer...

Answer 9

The closest I was able to find to what you need for your 2" valve on your grey tank, is the: -LaSalle Bristol Cable-Actuated RV Waste Valve for Gray Water Tank #34466N11AB36GM. This cable actuated waste valve is American made, has a 36"…

view full answer...

Answer 10

Unfortunately we don't have specifications like how far the pipe is from the edge of your travel trailer. But the LaSalle Bristol Cable-Actuated RV Waste Valve #34466N11AB36GM is designed to replace the waste valve from your travel trailers…

view full answer...

Answer 11

Remove the locknut from the cable housing assembly of the #34466N11AB96GMA. Feed the cable through the mounting bracket or hold in the wall of chassis. Feed the locknut back over the cable and fasten securely to the backside of the bracket or wall.…

view full answer...

How Does Cable Separate from RV Waste Valve

Product Page this Question was Asked From

Continue Researching