Recommended Wiring Converter to Combine 3 Wire System to Two Wire System for Extra LED Tail Lights
Question:
want to add a combination brake and signal led lamp to each side of my motor home it has 3 wires 2 inputs and 1 ground. problem is MH has a double filiment normal bulb for tail light and brake light in one light and a separate light that is only for signal lights. there is also center mounted brake lamp I want to wire the additional new led lights to work as both brake and signal lights in conjunction with the original lights the original lamps are low and vision is restricted when using our tow vehicle any help will be appreciated thanks
asked by: Fred
Expert Reply:
To get your separate light signals from your motorhome to have the combined brake and turn features you will need the Roadmaster Brite-Lite Wiring Converter # RM-732. It is very normal for your tail light/running lights to be on the same brake light with a dual filament, so you will simply want to capture the turn signal and brake light wires separately into the converter and then bypass the converter with the tail light/running lights. So on your new LED fixtures with 3 wires, you will connect the running light to one of the wires, the combined stop and turn to the other, and then run the ground to the third.
The Hopkins Tail Light Converter Kit with 4-Way Flat Connector - LED Compatible # HM48895 can work in the similar way, you will simply cut the 4-way off the end to make your connections. This converter will also use the tail light/running light feature instead of that going around the converter.
Products Referenced in This Question
Roadmaster Brite-Lite Wiring Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- Roadmaster
more information >
Product Page this Question was Asked From
Hopkins Tail Light Converter with 4-Way Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 6 Feet Long
- Universal Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Q&A: Semi Trailer Light Function Locations on Heavy Duty 7-Way Pin Connection
- Q&A: Converting From 7-Way Round to 7-Way Flat Connector
- Q&A: How Much does the Gen-Y # 325-GH-1625 Weigh?
- Q&A: Latch Repair Kit For Bulldog A256 2-5/16" Ball Latch Coupler
- Article: Most Popular Wheel Bearings
- Q&A: Recommended RV Door Latch for 5" x 5" Opening
- Q&A: Recommended Air Bags for 2022 Ford F-250 Super Duty with B&W Underbed Gooseneck Trailer Hitch
- Article: Trailer Wiring Diagrams
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Trailer Lighting Requirements
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)