Yakima Ridgeback Frame Cradle Recommendations

Question

Question:

Good morning, I previously ordered your number 8880597 and it worked great. I need the other side replaces too. It has a second strap. It is for the right side as I am looking from the back, what part number should I order? Thank you!

asked by: Jim

0

Expert Reply:

The matching frame cradle to use with the part # 8880597 that you referenced on your Yakima Ridgeback is the part # 8880598 that you referenced. This is the cradle that has the anti-sway cradle too with the lower strap that grabs the frame of the bike.

expert reply by: Jameson C

0

Answer 1

Thanks so much for the photos, they were very helpful. To replace all four cradles, what you need is two of the Replacement SuperCush Anti-Sway Cradle and ZipStrips #8880598 (which has the upper and lower ZipStrip) along with two of the Replacement…

view full answer...

Answer 2

The Yakima Little Joe 3 bike carrier is something of a bare-bones bike carrier and so I understand your interest in giving it an upgrade by using the SuperCush Anti-Sway Cradles #8880598. I measured the rack arm diameter and found it to be…

view full answer...

Answer 3

The Yakima Replacement SuperCush Anti-Sway Cradle and ZipStrips #8880598 that you mentioned, work with 1-1/8 inch arms, such as the Yakima RidgeBack #Y02458. If you have an Inno rack with arms that measure 1-1/8 inch then they could potentially work…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Yakima Ridgeback Frame Cradle Recommendations

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching