Could etrailer.com Cargo Area Protector # E98877 Be Used in Truck

Question

Question:

hello,is this cargo protector just for cars,suvs?i have a 2015 ford f-150 lariot extended cab,will this fit?thanks

asked by: Marc P

0

Expert Reply:

The etrailer.com Cargo Area Protector # E98877 that you referenced is pretty big as it was designed with the rear of SUVs in mind, but it can fold down smaller as needed for a smaller vehicle or you could use one of the smaller included sections with your 2015 Ford F-150. It has three sections with the following dimensions:

Seat back: 23-5/8" long x 48" wide
Trunk floor: 39-7/16" long x 48" wide
Bumper: 15-3/4" long x 48" wide

You might just use the section that fits the area of your truck you want covered the best.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Access Custom Truck Bed Mat #A25040229 that you referenced measures 75 inches long and 50 inches wide. It can be trimmed to fit a smaller space but just keep in mind that the integrated snap buttons are positioned pretty close to the edges so…

view full answer...

Answer 2

The only custom fit cover that we carry for the 2018 GMC Yukon that extends from the back of the front seats to the end of the cargo area is Canine Covers part #DCL6360PF. The Canine Covers allow you to either fold down the back seats and lay the…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 10

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 11

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 12

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Could etrailer.com Cargo Area Protector # E98877 Be Used in Truck

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching