Where in the Hole for a Block Heater on a 2014 Toyota Corolla

Question

Question:

where is the hole to fit a block heater on a corolla 2014

asked by: Maurice

1

Helpful Expert Reply:

The freeze plug hole for the Kat's Heaters Custom Fit Engine Block Heater part # KH11813 which is a fit for your 2014 Toyota Corolla with the 1.8L engine will be located in rear of the engine (towards firewall) on the left hand (driver) side. I have attached a diagram of the freeze plug hole location for you as well.

expert reply by: Conner L

1

click to enlarge

Answer 1

I checked with Kat's and they state that the slot location for installing the Kat's Block heater part #KH11813 on your 2016 Toyota Tundra with a 5.7 liter is in the left rear area of the block. It will be in a similar spot as what you…

view full answer...

Answer 2

For your 2018 Toyota RAV4 with the 2.5L I4 engine the Kat's Heaters Custom Fit Engine Block Heater #KH11813 will work perfectly. This cartridge heater will clip right into the cavity of your engine block and submerges in the coolant to keep…

view full answer...

Answer 3

Thank you for the images Barb, but you are going to have to take a couple measurements to verify what is going to work best for your exact situation. It looks like you have a 2019 Toyota Tundra with the B&W Turnoverball Underbed Gooseneck Trailer…

view full answer...

Answer 4

According to manufacturer's application guide your 2018 Toyota RAV4 LE with a 2.5L 4-cylinder engine would need the Kat's Heaters Custom Fit Engine Block Heater #KH11813 and it would need to be installed in the 'RL' position in the…

view full answer...

Answer 5

I checked with Kat's and the Kat's Heaters Custom Fit Engine Block Heater #KH11813 that fits your 2013 Lexus RX 350 will install in the left front position, as indicated in the cut out of the manual I attached. Kat's does recommend…

view full answer...

Answer 6

Kat's does recommend coating the cartridge with NSCG silicone grease G-624 before inserting the cartridge heaters like the #KH11813 into the block.

view full answer...

Answer 7

As long as you have found the correct hole in your 2015 Toyota Tacoma the Kat's heater part #KH11813 would be correct for it and should slide right in. Since the hole is somewhat difficult to access you are most likely not angling it in…

view full answer...

Answer 8

The correct engine block heater for your 2017 Toyota RAV4 Limited with the 2.5L I4 engine is the Kat's Heaters Custom Fit Engine Block Heater part #KH11813. According to Kat's, the block heater will need to be installed on rear left potion of…

view full answer...

Answer 9

The Kat's Heaters Custom Fit Engine Block Heater - Cartridge Style - 120V - 400 Watts #KH11813 is a confirmed fit for the 3.5L V6. You should not need to alter the element or clip in any way and doing so is not recommended. You may want to…

view full answer...

Where in the Hole for a Block Heater on a 2014 Toyota Corolla

Product Page this Question was Asked From

Continue Researching