Aries Aero Tread Running Board Fit for 2019 Kia Sorento EX

Question

Question:

Do Aries Aero Tread Runningboards part # AA2061024 Fit 2019 Kia Sorento EX. I Just bought a 2019 Kia Sorento. Will the 2018 brackets and board fit ?

asked by: Duane

0

Expert Reply:

For your 2019 Kia Sorento, the compatible running boards are the Aries AeroTread Running Boards w/ Custom Installation Kit - 5" Wide - Aluminum - Polished Stainless # AA2051028 or Black # AA2061028.

expert reply by: Jason S

0

click to enlarge

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 3

Hey Chris, The Yakima RuggedLine HD Mounting System for LockNLoad Platform #Y43DJ is not compatible with a 2021 Toyota Highlander unfortunately. If you have flush mounted rails that run from front to back then you could go with the following…

view full answer...

Answer 4

If you are looking for a single pole connector to use as a charge line for the batteries of your RV the part numbers #PK11851 and #PK11852 would be a great choice. These connectors can accept wire gauge up to 00.

view full answer...

Answer 5

When you are hardwiring a trailer brake controller like the Prodigy P2 #90885 the red wire connection that provides the triggering signal to the controller should be made to the wire on the COLD SIDE of the brake light switch circuit. This is the…

view full answer...

Answer 6

If your 2020 Kia Sorento has the factory tow package, there will be a tail light wiring connector behind the rear tire of the driver side, on the outside of the frame rail. As shown in the attached photos, an underbody cover will need to be removed…

view full answer...

Answer 7

If your 2019 Kia Sorento has the factory tow package then I recommend starting with the Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector #C56332 which will connect to the wiring harness located along the…

view full answer...

Answer 8

In order to install a 5-Way connector on your 2019 Kia Sorento you will need to start with a 4-Way harness if you don't already have one. For this the Curt T-Connector #C56332 will work perfectly if the Sorento is equipped with the factory tow…

view full answer...

Aries Aero Tread Running Board Fit for 2019 Kia Sorento EX

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching