Troubleshooting Output Circuit of Brake Controller Hot all the Time 2018 Honda Ridgeline AWD RTL-T
Question:
I installed a Tekonsha P3 controller using a 3070-P wiring harness. I keep a “No Trailer Connected” message when I activate the manual arm or when I go to setup. During troubleshooting I discovered that I am getting 12v power thru the black “power” wire and the blue “e-brake output” wire. The blue wire is output from the brake controller. Tekonsha tech said I have a wiring problem on my new Honda, Honda Service dept at my dealer says the truck wiring is fine! Any suggestions?
asked by: Michael R
Expert Reply:
Tekonsha would be correct. But what I would first do is try disconnecting the brake controller and then checking to see if the blue wire has voltage all the time still. If so then it's definitely the wiring of the vehicle. Also test the brake output circuit of your 7-way which is the 5:00 pin to see if there is voltage there all the time too. If instead you find that the blue wire only has voltage when the controller is connected the problem is the controller and it should be replaced.
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: How Does Brake Controller Install on Freightliner S2RV Chassis
- Q&A: Parts Needed to Add 7-Way & Brake Controller on 2023 Kia Sportage
- Q&A: Wiring Configuration for Tekonsha Prodigy P3 Trailer Brake Controller 90195
- Q&A: Replacement Lid and Lift Arm for Dometic 810263