Picking Out Replacement Lock Core for Thule Ascent Cargo Box

Question

Question:

Is there a replacement lock for this model?

asked by: Arohl

0

Expert Reply:

I checked with Thule and for your Thule 603 Ascent cargo box we have replacement lock cores if that's what you need but we do not have replacement lock assemblies. To pick out a lock core you'd need to search our site for THLOCKNXXX where the X's equal your lock core number and the correct lock will be listed.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel studs…

view full answer...

Answer 6

The best hitch receiver for hauling a bike with your 2022 Subaru Ascent is going to be the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" item #C25VR. This hitch receiver mounts behind your rear bumper bar instead of below your…

view full answer...

Answer 7

To keep your back end from squatting, I recommend the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension item #CSS-1094R. These insert into your rear springs and keep your suspension from being pushed down by the weight of your…

view full answer...

Answer 8

The connector you are looking for to install the Curt trailer wiring kit part #C56040 on your 2019 Subaru Ascent is located behind the driver side rear panel in the cargo area. If you check out the picture I attached you'll see where to find it.

view full answer...

Answer 9

I might have some options for you but I wasn't able to reference the TDE Turbo Lube 48395 Oil Cap. Therefore, in order to find a replacement for this you'll need to measure the outer diameter of the threaded portion on the oil cap. The Oil…

view full answer...

Answer 10

I recommend to measure the inside diameter of your hub bore to switch out the oil bath caps with threaded Bearing Buddy Bearing Protectors. The closest we have to the 3.3 inches that would thread into your oil bath hub is Bearing Buddy Bearing…

view full answer...

Picking Out Replacement Lock Core for Thule Ascent Cargo Box

Product Page this Question was Asked From

Continue Researching