Troubleshooting Weak Trailer Brakes with New Magnets
Question:
I have got a 2004 Dodge 3500 1 ton I have had I got a Dexter 3 axle trailer 7000 lb axles under it and I can hit my brakes and it will not stop me I have put new shoes new magnets and wires and it will not stop me could there be a difference in the magnets that I put on
asked by: Sherman W
0
Expert Reply:
Most likely your trailer brakes are just out of adjustment. You will want to have the adjustment screw tightened to the point where the wheel locks up and then back it off 10 clicks. Check out the video I attached at the 4:25 mark to see the entire process.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Electric Trailer Brake Assembly - 10" - Right Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- RH
- 3500 lbs
- Brake Assembly
- Manual Adjust
- 10 x 2-1/4 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Replacement Dexter Brake Assemblies for 36-19 Assemblies
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Dexter Trailer Brake Kit To Replace Dexter 36-19 Brake Assemblies
- Q&A: Replacement Hub and Brake Assemblies that Fit Sure Trac 3,500 lb Axle
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Recommended Wet Bolt For Center Hole Of The CRE 3000 Equalizer
- Q&A: Replacement Bolt and Nut for MORryde Wet Bolt Kit part # MR46ZR
- Q&A: Replacement Hub for a Lippert LCI 126003 Hub
- Q&A: How to Initially Adjust the Dexter Nev-R-Adjust Electric Trailer Brakes
- Article: Trailer Tire Sizing
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Choose the Right Trailer Hitch Class