Installation of RV Holding Tank Heater Pad to Trailer Battery
Question:
Can I just run the wires direct to my camper battary installing an inline fuse ?
asked by: Paul
Expert Reply:
The ThermaHeat RV Holding Tank Heater Pad w/ Thermostat # 277-000163 can be run directly from your trailer battery if you use an in-line fuse or in-line circuit breaker like # 9506P. Most people utilize a switch like # PK34360 and # 16-1-1 wire sold by the foot to give an on/off option so you don't drain your battery when you don't need the heater on.
Products Referenced in This Question
In-Line Circuit Breaker - 20 Amp - Perpendicular Mount Bracket
- Accessories and Parts
- Wiring
- Circuit Breaker
- 20 Amp
- Pollak
more information >
Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 3-Blade - Red Pilot Light
- Accessories and Parts
- Wiring
- Switches
- Rocker Switches
- 20 Amp
- Pollak
more information >
Product Page this Question was Asked From
ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 25" Long x 7-1/4" Wide
- RV Fresh Water
- Winterization
- Holding Tank Heating Pad
- LaSalle Bristol
more information >
Continue Researching
- Q&A: Can ThermaHeat RV Holding Tank Heater Run to Inverter Instead of Battery
- Q&A: Difference Between the Blue Ox Alpha and Avail Tow Bars
- Q&A: Troubleshooting the Switch for Camco Propane to Electricity Converter Not Staying On
- Q&A: Do RV Gray and Black Water Tanks Require Heaters
- Q&A: Can Roadmaster Dual Hitch Adapter RM-077-4 be Used with Flat Towing Setup
- Q&A: Weight Distribution for a 2019 Jeep Cherokee Trailhawk and 2017 Palomini 177BH Travel Trailer
- Article: Flat Towing Package for 2019 Jeep Cherokee
- Q&A: Difference in Blue Ox Acclaim vs. Alpha Tow Bars
- Article: How (and Where) to Connect an RV Propane Grill
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams
- Article: How to Raise Your Travel Trailer Height
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)