Troubleshooting No 12V Power at 7-Way on 2014 Ram Truck
Question:
I just bought a 2019 hotshot trailer. All lights,brake lights, turn signals work. Trailer came with two flood lights and those do not work. The dealer from trailer tested the plug and it was not getting the 12 volt that it needs to turn flood lights on. Where and which is the fuse for that
asked by: Daniel A
Expert Reply:
If you aren't getting any power at the 12V pin on the 7-Way connector (which should be at the 1 o'clock position) for your 2014 Ram then a missing or blown fuse is the most likely cause.
I took a look at the online owner's manual for your truck and it looks like there should be a 30 amp fuse located in the F30 position inside the power distribution box (under the hood near the battery). Check to make sure this fuse is present and in good condition.
If this doesn't resolve your issue please let me know and I will be happy to look into this further.
Product Page this Question was Asked From
Continue Researching
- Q&A: Testing for Proper Voltage on the Brake Output Circuit
- Article: Trailer Wiring Diagrams
- Q&A: Can Electric Brake Controller Install and Function in Semi Truck with Air Brakes
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Replacement Circuit Board For Dometic Atwood Water Heater With Circuit Board 91346
- Q&A: No Power to 12 Volt on 7-Way of 2020 Ram 3500
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: What is Most Common Leaf Spring Length for 3,500 lb Trailer Axle
- Q&A: How to Tell if 2019 Toyota Highlander Has Factory Tow Package
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Troubleshooting Brake Controller Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)