Does Yakima Replacement Clamp Assembly # 8880737 Come in a Pair

Question

Question:

Replacement Clamp Assembly for Yakima SlimShady Roll-Out Awning Item # 8880737 Is this sold as a pair or individually??

asked by: Jason

0

Expert Reply:

The Yakima Replacement Clamp # 8880737 referenced in your question comes with 1 clamp assembly. For a pair you will just need to order 2 of the clamps. These are designed to fit the Yakima SlimShady Roll-Out Awning # Y36VR.

expert reply by: Chris R

0

Answer 1

Yes, you can use the Replacement Clamp Assembly #8880737 and Replacement Mounting Bracket #8880736 for the Yakima SlimShady will work for your Roam awning. We actually have a review from a customer who purchased this combination for the same exact…

view full answer...

Answer 2

The Replacement Clamp Assembly part #8880737 does look like the one you need but it is actually the Replacement Mounting Assembly for SkyRise Rooftop Tents part #8880735 which also comes with the brace that needs to be replaced along with the clamp…

view full answer...

Answer 3

The vertical spacing you're asking for is 1-1/2" for the Replacement Mounting Bracket for Yakima SlimShady Roll-Out Awning #8880736 (see attached). I confirmed this with my contact at Yakima.

view full answer...

Answer 4

The fit of the #8880736 is very tight to the lower base it attaches to and is mostly covered when the awning is installed. Since both of the brackets would have to come off at the same time it would take a thief who knew the awning setup very well…

view full answer...

Answer 5

I have a solution for you, but those parts are not available from Yakima at this time. Instead, you'll need to replace the entire assembly on your Yakima Slim Shady Awning #Y36VR. You can use the Replacement Clamp Assembly for Yakima SlimShady…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

I reached out to my contact at EcoHitch and she verified that the Hidden Trailer Hitch Receiver #306-X7137 will fit with the full size spare tire beneath your 2008 Toyota Highlander. You will want to lower/remove the spare during the installation…

view full answer...

Answer 10

The inside dimensions of the Malone Profile18S Rooftop Cargo Box #MPG910 are 76" long x 30" wide x 14-1/2" tall.

view full answer...

Does Yakima Replacement Clamp Assembly # 8880737 Come in a Pair

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching