Troubleshooting No Left Turn/Brake Light on Trailer
Question:
No left signal or left brake light on trailer I wired it up and at first everything thing worked now doesnt please help 2015 ram 1500
asked by: Robert
Expert Reply:
First thing you should do at this point is test the 7-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached. The left turn/brake circuit would be on the pin in the 9:00 position.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well.
Products Referenced in This Question
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Q&A: Does The Draw-Tite trailer Hitch Receiver Come With One Or Two Hitch Pin Holes
- Article: Trailer Wiring Diagrams
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Distance from Pin Hole Center to End of Bar on Reese Weight Distribution Shank RP63971
- Q&A: 4-Way Vehicle Side Trailer Connector that Can be Spliced Into Wires from Trailer Wiring Harness
- Q&A: Should 12 Volt Hot Lead on 7-Way Trailer Connector Be Hot All the Time, WIll it Drain the Battery
- Q&A: Will 12V Wire at Vehicle End Trailer Connector Be Hot Even When Truck and All Lights Are Off
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers