Jack Needed to Support Slide Out on 2018 Passport 2810BH with No Rails Under Slide Out
Question:
Hi. I have 2018 Passport 2810bh which has one slide out. On the bottom of the slid out, it doesnt have any rails or anything to use the stabilizer. It is just flat bottom. Do you have stabilizer for this slide out?
asked by: Justin K
Expert Reply:
Since you don't have the rails under your slide out the typical slide out supports like part # UF19-960003 wont' work but we do have another possible solution for you.
Brophy has some camper jacks that are meant to be used for supporting a truck bed camper but when I spoke with my contact at Brophy she said you could use them for your slide out too.
These come in varying weight capacities and max heights so you would just need to choose one that fits your application. Please note that the legs do need to be on level ground.
1,000 lbs with a 57" Lift - # CJ31
3,000 lbs with a 57" Lift - # CJ41
4,000 lbs with a 57" Lift - # CXHD
3,000 lbs with a 67" Lift - # CJ74
4,000 lbs with a 67" Lift - # CX74
Products Referenced in This Question
Brophy Cable Camper Jacks - 57" Max Lift Height - 1,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Stabilizer Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- 57 Inch Lift
- 2 Jacks
- Brophy
more information >
Brophy Cable Camper Jacks - 57" Max Lift Height - 3,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Stabilizer Jacks
- Steel
- 3001 - 4000 lbs
- Sidewind Jack
- 57 Inch Lift
- 2 Jacks
- Brophy
more information >
Brophy Cable Camper Jacks - 67" Max Lift Height - 3,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Stabilizer Jacks
- Steel
- 3001 - 4000 lbs
- Sidewind Jack
- 67 Inch Lift
- 2 Jacks
- Brophy
more information >
Brophy Heavy Duty Cable Camper Jacks - 67" Max Lift Height - 4,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Stabilizer Jacks
- Steel
- 3001 - 4000 lbs
- Sidewind Jack
- 67 Inch Lift
- 2 Jacks
- Brophy
more information >
Brophy Heavy Duty Cable Camper Jacks - 57" Max Lift Height - 4,000 lbs - Qty 2
- Camper Jacks
- Truck Camper
- Stabilizer Jacks
- Steel
- 3001 - 4000 lbs
- Sidewind Jack
- 57 Inch Lift
- 2 Jacks
- Brophy
more information >
Product Page this Question was Asked From
Ultra-Fab Slide-Out Supports for Motor Homes - 26" to 47" - Qty 2
- Camper Jacks
- Fifth Wheel Camper
- RV Motorhome
- Travel Trailer
- Stabilizer Jacks
- Steel
- 1001 - 2000 lbs
- 47 Inch Lift
- Not Mounted
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Determining the Best Top and Side Trim Options for an Enclosed Trailer
- Q&A: Troubleshooting Lippert Smart Jack Working Intermittently
- Q&A: Troubleshooting Lippert Power Jack Not Extending or Retracting But Motor Is Working
- Q&A: Replacement Faucet for Pop-Up Camper with Removable Spout
- Article: How to Store a Travel Trailer/Camper for the Winter
- Article: Converting Your RV Water Heater to Tankless
- Q&A: Do Slide Out Jacks Help on RVs with Slide Outs
- Q&A: Replacement Rear 5K Scissor Jack for 2020 Forest River Salem 33TS
- Q&A: Recommended Slide Topper Awnings for 155 Inch Wide Slide
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Rooftop Cargo Carriers
- Article: Don't Break Your Pipes or Your Wallet: Winterize and De-Winterize Your RV
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: RV Propane 101: How Does My RV's Propane System Work?