Does Power Wire of 2018 Toyota Sienna Have to Run to Battery
Question:
Why do you need to go all the way to the battery rather than tapping off another 12V source already in the vehicle? And if you must go to the battery, do you have a video or an explanation of how to route the wire through the. Inside of the car, or do you route it outside? Please clarify and thank you!
asked by: Gary K
Expert Reply:
Not all vehicles can handle the additional amperage draw of the trailer taillights on the vehicle taillight circuits. Those vehicles need setup that draws power from the battery. Some vehicles have higher rated circuits that can handle this, and others need to have the power drawn straight from the battery to protect the taillight circuits. If you run the wire to a power outlet on the vehicle you could potentially short it out as well in the event of a short. It also would void the warranty to run it like this too.
For your 2018 Toyota Sienna you need to install a harness that draws power from the battery to protect the taillight circuits. For that you would need the part # 118648 if you do not have an SE model. If you have an SE model you'd instead want the part # 118498. I also attached a help article on running the power wire for you to check out as well.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 525 lbs TW
- 3500 lbs GTW
- 3500 lbs WD GTW
- 2 Inch Hitch
- 525 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Differences Between Curt, Draw-Tite, and etrailer.com Trailer Hitches for 2019 Subaru Outback Wagon
- Q&A: Base Plate and Tow Bar Recommendations for a 2018 Ford Focus Hatchback
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is Ground Clearance for Draw Tite Hitch Installed on 2017 Toyota Sienna
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Towing Capacity of 2017 Toyota Sienna LE with Tow Package
- Article: Which Hitches are Made in the USA
- Q&A: Tongue Weight Rating of 2016 Toyota Sienna When Using the Draw-Tite Max-Frame # 76112 Trailer Hitch
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Ball Mount Basics: Weight Capacity, Class, and Size