How Should Replacement Extend/Retract Switch of Lippert A-Frame Jack LC285318 Wire In
Question:
wire the retract extend switch
asked by: Lawrence Z
Expert Reply:
The replacement extend/retract switch for the Lippert powered A-frame jack part # LC285318 that you referenced is the part # LC226023.
I reached out to a representative of Lippert, who explained that while there was no wiring diagram available, when installing the Replacement Extend / Retract Switch Assembly # LC226023 in your Lippert Electric Trailer Jack # LC285318, it will wire up exactly the same as the original, so what you can do before removing the original switch is take a photo of the back of the original and how it is wired and use that as a simple reference to guide you on how to replicate the wiring.
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: Hitch Extender For 2-1/2 Inch Hitch For Weight Distribution
- Q&A: Lowest-Profile A-Frame Trailer Jack For Tailgate Clearance
- Q&A: Replacement For A-Frame Tongue Jack on Lippert Electric Ground Control TT
- Article: RV Pre-Departure Checklist
- Q&A: Replacement Toggle Switch For Lippert Power Stance Trailer Jack
- Article: Trailer Wiring Diagrams
- Q&A: Correct Replacement for an Atwood Water Heater GC6AA-9E
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill
- Article: Most Popular Wheel Bearings
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Measure for Trailer Hitch Drop