Mounting of Stromberg Carlson RV Shower Curtain

Question

Question:

Is it recommended to caulk behind the mounting brackets or is that necessary? Also I guess I can assume if the factory shower rod is mounted now then this should just be a screw-in in the same location and be solidly mounted.

asked by: Roger D

1

Helpful Expert Reply:

You are correct that the Stromberg Carlson Extend-A-Shower Shower Curtain Rod # EXT-3542 does install with the use of the four included stainless steel screws. As for caulking behind the mounting brackets that is not necessary with this product, no.

expert reply by: Kyle S

1

Answer 1

You can install the Stromberg Carlson Extend-A-Shower Shower Curtain Rod #EXT-3542 on the outside of your truck bed camper. However, it requires you to drill into the side of the camper. Removing the entire curtain rod would require you to remove…

view full answer...

Answer 2

The Snoblock Snow and Ice Windshield Cover #288-06603 that you referenced features a weather-resistant polyester construction that's going to work great with rain, snow, ice, and any other moisture-related output the clouds might have in…

view full answer...

Answer 3

For as many units of the #288-06603 as we've sold, not one customer has reported any sort of damage to their vehicle door's weatherstripping. So, it's safe to say that unless you plan on leaving the cover on for months and…

view full answer...

Answer 4

The etrailer Snoblock Snow and Ice Windshield and Wiper Blade Cover - 70" Wide x 39" Tall #288-06603 is a great fit for your 2002 Bigfoot 30MH29RQ Class C motorhome and is my recommendation. There are a couple other options like the…

view full answer...

Answer 5

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion…

view full answer...

Answer 6

Although we do not have a direct replacement for the Dicor V19582-EJN, the Replacement Wheel Master Lug Nut Cover for Wheel Liner - Qty 1 #WMRMT9061 will fit a 22 millimeter lug nut. From what I have found, the jam nut you are looking for has been…

view full answer...

Answer 7

I have a solution for you but there is not a direct replacement for your old Atwood unit. Instead, you can use the 2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - White #RS34FR to replace your old Atwood carbon monoxide detector, but…

view full answer...

Answer 8

Bumpers for most RV's will typically be 4" x 4", but there unfortunately isn't a guide to tell us what size bumper your 2004 Four Winds 5000 Class C motorhome. The 24x64 etrailer Cargo Carrier for RV Bumper #e83YR…

view full answer...

Answer 9

You certainly can replace your tub with a shower in your travel trailer. This would be the same as if you were swapping out the tub in your home for a shower. I have linked our selection of shower pans for you to filter through but you will need to…

view full answer...

Answer 10

The Stromberg Carlson Extend-A-Shower Shower Curtain Rod for RVs #EXT-3542 will work with your 32 inch wall to wall measurement "as is" if you don't need the space saving fold. If you want that function, you will need to…

view full answer...

Answer 11

Yes the brackets of the 24x64 etrailer Cargo Carrier for RV Bumper #e83YR that you referenced would get bolted to the frame rails under the bumper to give it more support so that you could carry heavier items like generators.

view full answer...

Answer 12

There are a total of four pivot points on the Stromberg Carlson Extend-A-Shower Shower Curtain Rod part #EXT-3542S. The bar has two pivot points and each mounting foot has a pivot point. The pivot points will allow you to flip the rod in or out…

view full answer...

Mounting of Stromberg Carlson RV Shower Curtain

Product Page this Question was Asked From

Continue Researching