How to Pick Out Landing Gear Trailer for 36 Vision Sportser
Question:
36 new vision sportser. Both tubes are 2.5 x 37.5 length Brackets 22.5 apart on coach and 19.5 on tube What is my solution ? Left side wont work so thought I would all except motor. Thanks
asked by: Harold H
Expert Reply:
In order to pick out a direct replacement for the landing gear on your 36 Vision Sportser we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # BD500162.
I attached a picture that shows the dimensions that this landing gear set would fit with.
The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.
If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.
Products Referenced in This Question
Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 7001 - 8000 lbs
- Landing Gear
- Sidewind Jack
- 36 Inch Lift
- Bolt-On
- 2 Jacks
- Bulldog
more information >
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Replacement Lead Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacment Landing Gear Leg for Atwood Landing Gear
- Q&A: Replacement Leg for Lippert Ground Control 2.0 LC241846
- Q&A: Are Replacement Parts for Atwood Landing Gear Available or Will Another Brand Fit
- Article: Trailer Tire Sizing
- Q&A: Replacement 14,000 lb. Hydraulic Jack Assembly for Lippert Level Up Systems
- Q&A: How to Measure to Pick Out Replacement Landing Gear for a Trailer
- Q&A: Replacement Power Distribution Panel for Iota IDP-240
- Q&A: Replacement Lead Landing Gear Leg for a 2008 Carriage Cameo 5th Wheel Trailer
- Article: How to Choose a Bike Rack for a Motor Home or RV
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Stability Control for Heavy Duty Vehicles
- Article: What Exactly is Tongue Weight?