Replacement Landing Gear Parts for 2007 Montana 5th Wheel Trailer
Question:
Thank you very much for help with the part numbers. I believe I will also need the gearbox. It’s the piece that goes on the cross bar that if needed will fit the manual crank lever into it.
asked by: Jen
Expert Reply:
Lippert actually made a unique landing gear system for your 2007 Montana 5th Wheel Trailer. For the replacement Lead Leg you will use # LC178653 and for the Follow Leg you will use # LC178652. To replace the motor you will need the Stromberg Carlson # LG-142178, which features a 5,500 rpm speed and a 5,500 pound weight capacity.
Products Referenced in This Question
Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Replacement Lead Leg for Keystone Montana 5th Wheel Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Gearbox
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Brake Assemblies and Hub/Drums for 15k Dexter Axle
- Q&A: Replacement Trailer Wheel for Dexstar Wheel 17-293
- Article: Replacement Automotive Lighting
- Q&A: How Many Transfer Switches are Needed to Switch from Shore Power to a Genreator, and An Inverter?
- Article: How to Charge a Dump Trailer Battery
- Q&A: Solution for Squeaky/Noisy Trailer Suspension with Equa-Flex Equalizers
- Article: Trailer Hitch Receiver Sizes
- Article: Trailer Tire Sizing
- Q&A: Trailer Grease Seal to Replace 127194TB
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Calculating Portable Generator Power Needs
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Q&A: Ceiling Garnish For a Dometic Fantastic Roof Vent Fan Model 1450
- Article: Testing Trailer Brake Magnets for Proper Function
Jen
8/8/2018
Thank you very much for help with the part numbers. I believe I will also need the gearbox. It’s the piece that goes on the cross bar that if needed will fit the manual crank lever into it.