Actuator and Motor Assembly for Venture Slide-Out

Question

Question:

It is a Venture V-Tech

asked by: Scott S

0

Expert Reply:

There is no database of trailer-specific parts available so you will need to know the manufacturer and model of your slide-out, which you may be able to find in our owner's manual; do you know if it is a Lippert Components Through-Frame Slide-Out?

expert reply by: Kyle S

0

Scott

8/8/2018

It is a Venture V-Tech

Reply

Kyle S.

8/8/2018

For your Venture V-Tech, which is a through-frame slide-out, you can use the Lippert Components Venture Actuator and High Speed Slide-Out Motor # LC168956.

Reply

Answer 1

The outside diameter of the outer tube of the Lippert Components Venture Actuator and High Speed Slide-Out Motor #LC168956 that you referenced is 2 inches. I confirmed this with Lippert and attached a dimensional picture of this for you to check…

view full answer...

Answer 2

Based on the numbers and RPM you listed on your Dutchman 2007 trailer the correct slide out motor setup you need is the part #LC125802 that is a Tuson High Speed 18:1 9,000 RPM slide out motor.

view full answer...

Answer 3

The correct replacement motor for your 2021 Forest River Sandpiper 5th wheel is going to be the Replacement 18:1 Tuson Motor for Lippert Through-Frame Slide-outs #LC125802. The 131903 part number you're looking at has to do with the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

Thanks for the info you listed. Based on that the correct replacement motor is the part #LC295380.

view full answer...

Answer 8

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 9

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 12

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Actuator and Motor Assembly for Venture Slide-Out

Product Page this Question was Asked From

Continue Researching