Hub Recommendaiton for Trailer with 5 on 4-3/4 inch Bolt Pattern
Question:
I am using a car that has a bolt pattern of 5 on 4 3/4 pattern and i would like to pull my trailer with the same pattern. Is there a hub that is available to replace the shaft and hub for this change? A chevy truck pattern would be my next choice.
asked by: Gary F
0
Expert Reply:
We do have hubs that have the 5 on 4-3/4 inch bolt pattern you mentioned for a 3,500 lb trailer axle like the etrailer.com hub part # AKIHUB-5475-35-K.
You'd need to verify that you axles are 3,500 lb axles though to know if this hub will fit. Typically the capacity is listed on the axle or on the VIN plate up near the coupler.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-3/4 - Pre-Greased
- Trailer Hubs and Drums
- Hub
- Pre-Greased
- Standard
- L68149
- L44649
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-3/4 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Pintle-Hitches
- Article: Trailer Wiring Diagrams
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Picking Out Replacement Axle for Snowbear 550LHD Trailer
- Q&A: Safe Max Tire Pressure for Trailer Tires with 110 Max PSI Rating
- Q&A: What Should Tire Pressure be for a Load Range G 110 psi Tire
- Q&A: Determining Correct Replacement Hubs for Dexter 8-286 Hubs on 2,500 Pound Axle
- Q&A: Identifying AL-KO Axle Capacity on Tandem Axle Trailer
- Q&A: Dexter 7,000 lb Hydraulic Drum Brake Kits to Replace 023-340-00
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Trailer Wheel with Bolt Pattern 5 on 4-3/4 inches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)