Stromberg Carlson RV and Camper Hitch # BA-100 Installation
Question:
do you have instructions on line on how to install?
asked by: Michael
0
Expert Reply:
The Stromberg Carlson 2" Motor Home Hitch Receiver for 4-1/2" x 4" Bumpers - 200 lbs # BA-100 does not have manufacturer instructions for installation available online. I've attached a video to assist but the installation is simply tightening the 4 attachment bolts with wrenches or sockets so that the top and bottom plate are parallel and tight to the bumper.
This product is not for towing and not to be used with an adapter or extender. It is only rated for use with hitch-mounted RV-approved accessories.
expert reply by:
Jason S
0
Product Page this Question was Asked From
Stromberg Carlson 2" Motor Home Hitch Receiver for RV Bumpers - 200 lbs
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 4-1/2 x 4 Inch Bumper
- 200 lbs TW
- 2 Inch Hitch
- Bolt-On
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement 4-Pin Switch for RV Awning
- Q&A: How to Wire Solera Smart Arm 12V Power RV Awning
- Q&A: What are the Dimensions of Curt Hook with Spring Loaded Safety Latch # C81840
- Article: Trailer Tire Sizing
- Q&A: What Does E6 Furrion Thermostat Indicate
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Replacement 250-031468 Seals Needed for Reliable Oil Bath
- Q&A: Are Hollywood Destination Bike Rack Cradles Made of Hard Plastic
- Q&A: Recommendation For Increasing Strength of Rear Bumper Attached to Spacers Off Of Trailer Frame
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: How to Charge a Dump Trailer Battery
- Article: How to Choose the Right Trailer Hitch Class
- Article: Best Hitch Cargo Carriers