Is the K-Source Universal Towing Mirror # KS3891 Available in a 2 Pack

Question

Question:

Do these come in a pack for drivers and passenger side?

asked by: Richard

0

Expert Reply:

The K-Source Universal Towing Mirror # KS3891 is available in a pack of 2 with part # KS3891-2. The mirror actually fits both the driver and passenger sides so it doesn't matter which one is installed on which side.

I have attached some review videos for you to check out as well.

expert reply by: Jon G

0

Answer 1

With the 2022 Toyota Tundra being all new and using different mirrors we have tested the K-Source Universal Towing Mirrors #KS69ZR on your truck. I have linked a video below that shows the installation and fit of these mirrors. Currently there are…

view full answer...

Answer 2

Both of these mirrors are designed to be a universal fit with a manually adjusting mirror, but the K-Source #KS69ZR has a rubber strap that is not ratcheting. The #KS3891 has a ratcheting strap with a different strap that allows you to get a bit…

view full answer...

Answer 3

I contacted CIPA about if there are mirrors for the 2022 Toyota Tundra in the plans. They informed me that there is currently nothing in the works for the 2022 Tundra. We have the K-Source Universal Towing Mirrors #KS69ZR which can be used on your…

view full answer...

Answer 4

As long as your horse trailer features a 4 inch diameter outer tube (which is pretty standard) the B&W Extend-A-Goose Gooseneck Coupler #BWTEXA4200 that you referenced will work really nicely to replace its inner tube. It will provide a 10…

view full answer...

Answer 5

I've attached a picture with three different measurements for the B&W Extend-A-Goose Gooseneck Coupler - 2-5/16" Ball - 10" Offset, #BWTEXA4200. It is 12 inches from the base or bottom of the coupler to the center of the lowest pin…

view full answer...

Answer 6

By nature, there is always going to be stress on the vertical tube when towing with a gooseneck but the B&W Extend-A-Goose Gooseneck Coupler #BWTEXA4200 is not going to cause additional stress that makes using your gooseneck unsafe. You only need…

view full answer...

Answer 7

The B&W Extend-A-Goose Gooseneck Coupler, part #BWTEXA4200 you referenced is designed to be able to attach to the inner tube on a gooseneck trailer and provide an additional 10 inches of clearance from your truck cab for your trailer. This…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Is the K-Source Universal Towing Mirror # KS3891 Available in a 2 Pack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching