What is the Width of the Ultra-Fab Steel Roller for RVs
Question:
Could you provide me the ID mesurements of this product, also how far back is the hole for the pin location on the bracket.
asked by: JOE D
0
Expert Reply:
The inside width of the Ultra-Fab Steel Roller for RVs, # UF48-979020, is 2-1/2 inches, the standard outside width of a 2 inch trailer hitch receiver tube. From the center of the hole in the bracket to the edge of the bracket is approximately 1 inch. The hole accepts a 5/8 inch diameter hitch pin.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Ultra-Fab Steel Roller for RVs with 2" Trailer Hitches
- RV Skid Wheels
- Hitch Mount
- Bolt-On
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: How to Prevent the Trailer Hitch from Scraping the Ground on a 2015 Subaru Legacy
- Q&A: Dimensions Of Ultra-Fab Steel Roller
- Q&A: Can Weight Distribution System Be Used on Aluminum Trailer Frame
- Q&A: Adding Rollers To a Trailer Hitch Receiver On a 2011 Chevrolet Cruze To Prevent Digging Into Ground
- Q&A: Solution for Fifth Wheel Dragging When Entering Steep Driveway
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Q&A: Drag Roller Recommendation for Boat Trailer with Prop Protector Cut Out
- Article: Hitch Adapters and Extenders
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: How to Rent an RV
- Article: Trailer Maintenance Schedule
- Article: The Best Boat Bumpers
- Article: Trailer Wiring Diagrams
- Article: Stability Control for Heavy Duty Vehicles