Installation of Redarc Tow Pro Elite on 2018 Chevy Silverado

Question

Question:

What harness/adapter would I need to install a Tow Pro Elite in a 2018 Silverado 1500?

asked by: Dustin

0

Expert Reply:

To install the Redarc Tow-Pro Elite, part # RED44FR, in your 2018 Chevy Silverado 1500 use the # 3016-S adapter. The connector end plugs in to the port under your truck's dash and the blunt ends need to be wired to the Redarc controller color to color.

expert reply by: Charles S

0

Answer 1

It sounds like you are having trouble removing your weight distribution spring bars from their lift brackets on the trailer frame. When its time to unhitch the trailer and truck what you want to do is use your trailer tongue jack to lift the…

view full answer...

Answer 2

With any weight distribution system you will want to remove the spring bars every time you encounter any tight maneuvering situation. So if you were reversing your trailer and the trailer did not swing too far to one side or the other you should be…

view full answer...

Answer 3

Active calibration of the Tow Pro Elite #RED44FR occurs with or without a trailer connected. I attached a page I took from the instructions that shows the active calibration for you to check out.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

To install the TorkLift PowerArmor Locking Battery Box #TLA7700L you'll need to use the included self-tapping screws to mount the box to your trailer tongue. You can do this either directly to your frame, using the extension brackets if they are…

view full answer...

Answer 10

The holes on the bottom of the TorkLift PowerArmor Locking Battery Box #TLA7700L aren't necessarily designed for mounting the box and are really there to allow moisture to escape and as access holes for wiring. According to the instructions there…

view full answer...

Answer 11

If your 2022 Chevrolet Tahoe does not have the factory tow package then the plug may not be there. If this is the case you would need to hardwire in a brake controller. If your Tahoe does have the tow package then the plug will be under the dash. The…

view full answer...

Answer 12

The Torklift Battery Mounting Box part #TLA7708R or #TLA7700L that you referenced can mount to the brackets you have on your trailer as there are several holes on the bottom of the box that you can use to run bolts through to then attach to your…

view full answer...

Installation of Redarc Tow Pro Elite on 2018 Chevy Silverado

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching