Availability Of 1-7/8 Inch Hitch Ball Made In USA

Question

Question:

The chrome plating wore off my brand new Curt C40002 ball during first usage. Do you carry a 1 7/8 ball that is made in the USA?

asked by: Richard R

1

Helpful Expert Reply:

You might be interested in a Convert-A-Ball Interchangeable Ball Set # 901B. This product is made in the USA and comes with an interchangeable hitch ball that will give you the option to easily change between a 1-7/8 inch and a 2 inch ball.

expert reply by: Timothy G

1

Answer 1

I reached out to my contact at Draw-Tite and for the 2005 Ford E-450 there isn't a custom fit hitch available. There is also not a Class IV or Class V hitch available from any of our manufacturers for your chassis. The largest hitch I can…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

You're correct. The repalcement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left.

view full answer...

Answer 7

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Availability Of 1-7/8 Inch Hitch Ball Made In USA

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching