Testing the Hopkins 4-Way Connector Not Showing Power on a 2009 Chevrolet Equinox
Question:
how can i tell if there is power from the connector coming from the car? i hooked everything up and cant get the light to work in any function.
asked by: Bob
Expert Reply:
You can test the Hopkins # HM11141265 by using a circuit tester like part # I26 while you have a helper activate the various light functions on your 2009 Chevrolet Equinox to make sure that the correct signals are coming through.
If they aren't then you have some bad wiring on your Equinox (granted you installed the fuses and relays and they are okay). If you do get signals then you have a wiring issue on your trailer. This can be traced back to a faulty ground or damaged wiring. Make sure your grounds are secure and connected to a clean, bare-metal surface and replace any wiring that is damaged and you should be good to go!
Products Referenced in This Question
Curt LED 4-Way Flat Connector (Vehicle End) Tester
- Electrical Tools
- Testers
- Tow Function Tester
- Black
- CURT
more information >
Product Page this Question was Asked From
Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Curt LED 4-Way Flat Connector (Vehicle End) Tester
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Shop: BOLT Trailer Coupler Lock - 1-7/8", 2", and 2-5/16" Couplers - For Nissan Key
- Shop: BOLT brand vehicle and hitch locks
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Q&A: Replacement Tires and Wheels for 1994 Coleman Roanoke Pop-Up Camper
- Q&A: Recommended Tires For 1994 Coleman Destiny Cedar XL With 5.30x12 Tires
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Q&A: What is Diameter of 5,200 lb Dexter Trailer Axle # 6340624
- Q&A: Mounting Hardware for Draw-Tite Hitch 76419 on Chevy Equinox
- Q&A: Troubleshooting Fitting M12-1.75X40mm Hex Bolts for etrailer.com Hitch on a 2009 Chevy Equinox
- Q&A: Bolt Size Used for Weldnuts for Installing Hitch on a Chevy Equinox