Dimensions of Square Direct Weld Jack
Question:
What are the dimensions of the very top square piece? Will it fit flush under 3x3 angle iron?
asked by: Andrew
0
Expert Reply:
I went out to the warehouse to measure the Square Direct Weld Jack # TJD-7000S and found that the top square piece measures 2-3/4" so it will fit flush under your 3" x 3" angle iron.
This jack will give your 15-3/8" of travel, has a lift capacity of 7,000 lbs and support capacity if 8,000 lbs.
expert reply by:
Kyle S
0
click to enlarge
Product Page this Question was Asked From
Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Fifth Wheel Trailer
- Gooseneck Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 6001 - 7000 lbs
- Sidewind Jack
- 28-7/8 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Multi-Function LED Trailer Light for Glo-Brite 9852-88
- Q&A: Installation Information for the Replacement Cables for Enclosed Trailer Ramp Spring # ERS160D96
- Q&A: Free-Backing Drum Brakes for M101A2 Military Dump Trailer
- Q&A: Hubs and Electric Brake Assemblies for M1010A2 Military Trailer
- Q&A: How Far Forward Should Motorcycle Wheel Chocks Be Installed in a Utility Trailer
- Q&A: Proper Front to Back Placement of Motorcycle Inside Enclosed Trailer
- Q&A: Diagnosing Overload Warning, No Brakes, On a Tekonsha Prodigy P3 Brake Controller
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Replacement Automotive Lighting
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Choose a Battery Charger