Trailer Disconnected Message When Driving
Question:
Problem...message is trailer disconnected. Beeps every 15 SECONDS! We cleaned contacts with contact cleaner. No help. New truck... new camper. Driving home from OBX. Help!!!!
asked by: Dave
Helpful Expert Reply:
I do not know what brake controller you have, but for an aftermarket brake controller there are steps you can take which I'll outline for you.
You will need to find out if the issue is on the brake controller, truck, or trailer. To test the brake controller, sever the blue wire a couple inches from the back of your controller. Then use a circuit tester such as # PTW2993 to test the end of the blue wire coming out of the controller. It should only have power when you apply the manual override; if it shows power at idle then there is an issue with the controller, and it will need to be replaced.
If the controller tests fine, reconnect the blue wire and move on to the truck side trailer connector. Often, corrosion or dirt may be the cause of a short in a trailer connector. Check the plug to see if there is any type of corrosion built up that may be hampering it's functionality.
You will also want to test the brake output pin on the 7-way socket; it should only show power with the manual override. If it shows power any other time then there is a short somewhere between the connector and the brake controller you will need to find.
If the truck side checks out, then it could be the wiring to the brake magnets or possibly the magnets themselves. Inspect the power wires to the magnets and look for wires that may be pinched or otherwise damaged and fix as necessary. You'll also need to make sure the ground wires are attached to bare metal surfaces and free of any paint, dirt or corrosion.
You'll want to visually inspect the magnets; if you can see the copper windings coming through the magnets will need to be replaced. To test the magnets, you can follow the help article I have linked. I have also attached some help articles on testing and troubleshooting brake controllers for you to check out.
Product Page this Question was Asked From
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)