Ball Mount Recommendation for 2 inch Hitch with Ball Mount with 3/4 inch Shank Diameter
Question:
I need a ball mount for a 2 inch hitch opening but with a 3/4 hole for the ball. What class is this? Towing capacity needed is less than 2500 lb. Do you have a ball mount which fits these requirements? Thanks
asked by: Keith
0
Products Referenced in This Question
Curt Reducer Bushing for Ball Mounts - 1" to 3/4"
- Accessories and Parts
- Trailer Hitch Ball
- Bushing
- 1 Inch to 3/4 Inch
- CURT
more information >
Product Page this Question was Asked From
Curt Dual Length Ball Mount for 2" Hitches - 1" Rise, 2-3/8" Drop - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- CURT
more information >
Continue Researching
- Article: How to Measure for Trailer Hitch Drop
- Article: Flat Towing Package for 1998-2006 Jeep Wrangler
- Article: Trailer Tire Sizing
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Is the Roadmaster Invisibrake a Proportional Braking System
- Q&A: 7-Way RV Trailer Connector Wiring Diagram
- Article: How to Measure the Bolt Pattern of a Trailer Wheel
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How To Tell If a 2020 GMC Terrain Has the Factory Tow Package for Trailer Wiring
- Q&A: Longer Ball Mount Recommendation for Adding Distance Between Hitch Ball and Bumper
- Q&A: Wiring a Trailer Brake Controller to a 2011 Chevy Silverado Tow Package Wiring
- Q&A: How To Flat-Tow 2006 Jeep Wrangler with Aftermarket Front Bumper
- Q&A: Can D-Rings of Barricade Jeep Bumper Okay to Use for Flat Towing