Recommended Over-Under Kit to Flip Axle on Trailer for More Ground Clearance
Question:
My camper seems to be very low to the ground. Is there something I can do to lift it for more ground clearance? It is a homemade camper on a 14foot single axle trailer with 13inch wheels.
asked by: Lisa S
Expert Reply:
To give your camper more ground clearance at the frame you can use the Dexter Trailer Springs Over-Under Conversion Kit # K71-384-00 for 2-3/8 inch diameter axles or # K71-385-00 for 3 inch diameter axles to "flip the axle". This means moving the leaf springs from under the axle to sit above the axle. This requires moving spring seats to the top and also using longer U-bolts. These kits will give you the difference in height of your axle diameter and the height of your leaf spring stack.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions for the MORryde ALLTREK 4000 Suspension Kit
- Q&A: Double Eye Leaf Springs For Tandem Axle Trailer With 10,500LB Rating and 24" Length on Spring
- Q&A: Does MORryde ALLTREK 4000 Cushioned Equalizer Sit Taller to Offset for Additiona Suspension Movement
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Q&A: What Leaf Spring Width SHould be Used with Dexter Over Under Kit # K71-384-00
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current