How Does Spare Tire Kit for Detail K2 Trailer Mount to the Trailer

Question

Question:

Just received the spare tire kit from you and there were no instructions on where or how it mounts. In the Box was the spare, nuts and a U shaped threaded rod. Does this rod go through the tire and bolt on the underside of the tongue...?

asked by: Bob M

0

Expert Reply:

The u-shaped threaded rod will go around the frame with the threaded ends sticking up (or out) through the wheel and then you bolt it down. I have linked a video showing a similar system that should help.

expert reply by: Michael H

0

Answer 1

You'll want to look at the GVWR (gross vehicle weight rating) which is the maximum amount the trailer plus its cargo can weigh. If you subtract the trailer's dry weight from the GVWR, you'll get the maximum weight of the cargo…

view full answer...

Answer 2

While I appreciate your ingenuity, you cannot install the light brackets in reverse so the license plate is on the right-hand (passenger's side) when installing the tail light assemblies of the Detail K2 Mighty Multi A-Frame Utility Trailer…

view full answer...

Answer 3

The coupler on the Detail K2 Mighty Multi A-Frame Utility Trailer #K2MMT5X7 is for a 2" wide frame and has 3" on center bolt holes. The Curt QuickPin No-Latch Trailer Coupler #C82CR will bolt in place of the coupler that comes with…

view full answer...

Answer 4

We don't have any trailer tires we can recommend that are intended for offroad use. The wheels have a bolt pattern of 5 on 4-1/2 inch so if you found a set of wheels and tires with a zero offset with a tire that's as aggressive as you'd…

view full answer...

Answer 5

In order to carry your tractor or ATV I actually recommend the Detail K2 Mighty Multi Utility Trailer part #K2MMT4X6, not the Detail K2 Mighty Multi A-Frame Utility Trailer part #K2MMT5X7. The reason for this is because the ramp on part #K2MMT5X7 is…

view full answer...

Answer 6

We don't have tow bars and base plates compatible with golf carts as they are not able to be flat towed. We do however have the Detail K2 Mighty Multi A-Frame Utility Trailer - 7-1/2' Long - 1,640 lbs #K2MMT5X7 that I recomend for a golf cart…

view full answer...

Answer 7

Yes, I suggest the 7-1/2' long Detail K2 Mighty Multi A-Frame Utility Trailer, #K2MMT5X7 that weighs only 451 lbs, but carries up to 1,640 lbs. This attaches to a 2" hitch ball, has a leaf spring suspension with a 2-Position bed that tilts…

view full answer...

Answer 8

In regards to the Detail K2 Mighty Multi A-Frame Utility Trailer part #K2MMT5X7, the inside width of the bed is 52" which is measured from inside each exterior wall, side to side. I'm not sure why you would need the width of the bed…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

How Does Spare Tire Kit for Detail K2 Trailer Mount to the Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching