How to Attach a Trailer with a 6-Pole Connector to a Vehicle with a 7-Way Connector
Question:
My stock trailer is 6 pole with a dedicated red wire for stop and dedicated wires for left and right turn where do I put the stop wire? 6 to 7 pole trailer wiring
asked by: Pete
0
Expert Reply:
I have attached a photo of where the wires need to be placed when using a 6-pole trailer connector. As you can see in this photo, the brake controller output wire will need to be placed in the 10 o'clock position when looking at the trailer side connector from the rear. If you also need an adapter to use the 6-pole trailer connector on a vehicle with a 7-way trailer connector then you can use part # 47549.
expert reply by:
Conner L
0
click to enlarge
Product Page this Question was Asked From
Adapter 7-Pole to 6-Pole - Universal
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 7 Round - Blade
- Plug Only
- 6 Round
- Hopkins
more information >
Continue Researching
- Q&A: 7-Way Trailer Plug Adapter or Compatibility with Lance Slide-In Truck Bed Camper
- Q&A: How To Plug 1997 Lance Truck Camper Into 7-way Connector On 2016 Ford F-250
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Intermittent Trailer Disconnected Message with Factory Brake Controller on Ford
- Q&A: Can Upper and Lower Torklift StableLoads Install on Truck at Same Time
- Article: Pintle-Hitches
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Mount a Truck Bed Camper
- Q&A: Is There an Adapter for Lance Truck Bed Camper to Standard 7-Way Trailer Connector
- Q&A: Fuse Bypass for Flat Towing 2009 Honda CR-V Equipped with Hopkins Harness HM56300
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)