What is the RPM Rating for the Lippert Landing Gear Motor # LC142178

Question

Question:

RPMs?

asked by: Mike

0

Expert Reply:

The Lippert Components Venture 5th Wheel RV Landing Gear Motor # LC142178 that you referenced is rated for 5500 RPM. I have attached a photo showing this rating on one of the stickers found on the unit.

expert reply by: Jon G

0

click to enlarge

Answer 1

The Atwood motor 71113 has been discontinued. The motor is a basic landing gear motor and we've been able to confirm the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor #LC141893 is the correct replacement. I've attached a…

view full answer...

Answer 2

We have the same part number basically twice through two different vendors here that are the exact replacement motor you are looking for. The Lippert part #LC142178 and the Stromberg part #LG-142178. They are the exact same motors and if I were you I…

view full answer...

Answer 3

It could be the motor but it could also be the screw/nut inside the jack leg that is causing the problem. Since you mentioned that it is hard to crank it manually I suspect that it is likely the screw and/or nut. On jacks that have an ACME screw the…

view full answer...

Answer 4

To determine the best landing gear option for your 1997 Forest River Sierra you'll need to measure the where your weld-stops sit to see if there is a matching set so that you can swap over without having to cut off the old mounting brackets and…

view full answer...

Answer 5

Yes, the Replacement Motor for Stromberg Carlson Electric Landing Gear #LG-142178 has been confirmed to replace the ADTH 1RV-200 landing gear motor you currently have so it would work for you.

view full answer...

Answer 6

For a landing gear set that has an electric motor with it, like the 6K Lippert Electric Landing Gear Set #LC333964, you can disconnect the motor and use the manual override handle. If you hear clicking still then it's the landing gear and…

view full answer...

Answer 7

To replace your existing Venture motor, the Lippert Components Venture 5th Wheel RV Landing Gear Motor #LC142178 is the correct replacement part for you. For an aluminum gear box, you are correct that you can use part #LG-179015. The #LC142178 motor…

view full answer...

Answer 8

From what I could find it looks like your ADTH 1RV-200 motor has a weight capacity of 6,500 lbs. You can use a motor that is rated for a higher capacity, like our replacement motor #LC142178 for Ram landing gear which is rated at 8,000 lbs. Just keep…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

What is the RPM Rating for the Lippert Landing Gear Motor # LC142178

Product Page this Question was Asked From

Continue Researching