What is the Depth of Optronics 2-Wire Pigtail?
Question:
I mistakenly ordered bracket A91BB with the two-wire pigtail A46PB to mount my AL90 marker lights. I think I should have ordered bracket A91BOB. Rather than return/re-order the bracket I was hoping I could cut the pigtail plug in half to make it a single wire pigtail that wouldnt interfere with the self-grounding portion of the the A91BB bracket. But it appears the plug is too tall as it protrudes from the back of the bracket when connected to the light installed in the mounting bracket. Given the depth dimension for the A91BOB mounting bracket is the same as the A91BB self-grounding bracket I am concerned using the A91BOB bracket and A46PB wire plug will also result in the plug protruding from the back of the bracket and preventing a true surface mount. Can you confirm a true surface mount no hole needed except for wire can be obtained with an AL90RB/AB light installed in an A91BOB mounting bracket using an A46PB two-wire pigtail.
asked by: Mick Y
Expert Reply:
I believe what you are asking is the depth of 2-Wire Pigtail # A46PB, and it is 0.6 inches, which is just 0.1 inches more than the depth of both mounting brackets you were referring to, # A91BOB as well as the self-grounding # A91BB. This means it would protrude ever so slightly from the back of the bracket when attached to lights # AL90RB and # AL90AB.
Products Referenced in This Question
Mounting Bracket for Optronics 90 Series or 91 Series Trailer Lights - Self-Grounding - Black
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Black
- Optronics
more information >
Mounting Bracket for Optronics A91, AL82, AL90, AL91, or AL191 Series Lights - Open Back - Black
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Brackets
- Black
- Optronics
more information >
FLEET Count Mini Thinline LED Clearance or Side Marker - Submersible - 1 Diode - Amber Lens
- Trailer Lights
- Clearance Lights
- Side Marker
- Rectangle
- Surface Mount
- LED Light
- 2-1/2L x 1-1/4W Inch
- Amber
- Optronics
more information >
FLEET Count Mini Thinline LED Clearance or Side Marker - Submersible - 1 Diode - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- LED Light
- 2-1/2L x 1-1/4W Inch
- Red
- Optronics
more information >
Product Page this Question was Asked From
Right Angle 2-Wire Pigtail for Optronics Trailer Lights - 2-Prong PL-10 Plug - 6" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 6 Inch Long
- Two Wire
- Right Angle Pigtail
- Optronics
more information >
Continue Researching
- Shop: Dexter Trailer Hub & Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Shop: Right Angle 2-Wire Pigtail for Optronics Trailer Lights - 2-Prong PL-10 Plug - 6" Lead
- Shop: Optronics Mini Red LED Clearance or Side Marker Light - Submersible - 2 Diodes - Clear Lens
- Shop: Mounting Bracket for Optronics A91, AL82, AL90, AL91, or AL191 Series Lights - Open Back - Black
- Shop: Thinline LED Clearance and Side Marker Light - Submersible - 3 Diodes - Rectangle - Red
- Shop: Optronics Trailer Reflector - Adhesive Backing - Rectangle - Red
- Shop: Hopkins Engager Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Top Load
- Article: Trailer Wiring Diagrams
- Video: Trailer Valet JXS Trailer Jack with Footplate Review
- Video: Optronics Lights Mounting Bracket Installation
- Video: Optronics Trailer Lights - Clearance Lights - 11212278B Review
- Video: Optronics Trailer Lights - License Plate Lights - LPL56CB Review
- Video: Optronics Trailer Lights A46PB Review
- Video: Optronics Trailer Lights - Clearance Lights - MCL914R1PG Review
- Video: Hopkins Trailer Breakaway Kit - Kit with Charger - 20400 Review
- Q&A: Why is 10 or 12 Gauge Wire Recommended for Electric Brake Assemblies
- Q&A: Clearance and Side Marker Light With Clear Lens and Red LEDs
- Q&A: What Hardware is Best for Mounting Trailer Light Mounting Bracket to the Trailer Surface
- Q&A: Does The Optronics LED Side Marker Light # AL91AB have 2 Male Connector Posts
- Q&A: Parts Needed to Install Optronics Submersible Red LED Clearance and Side Marker Light AL91RB
- Q&A: Size of Mounting Hole Required for Installing Optronics Grommet # A91GB
- Q&A: Optronics Mounting Bracket with Wedge
- Shop: Trailer Wiring
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Search Results: dual trailer plug
- Search Results: al90rb
- Search Results: power switch