How is Red Locking Tab of Curt Trailer Wiring Harness Manipulated to Unplug Connector
Question:
I have this exact connector on my vehicle but cannot figure out how to remove it from the back of the 7-pin connector. Your instruction on the link below say push the red tabs. Push both, or push it one way? I dont want to damage anything. h
asked by: Art M
0
Expert Reply:
The red tab on the Curt T-Connector Vehicle Wiring Harness # C55381 needs to be carefully pressed sideways to release it so that the connectors can be pulled apart according to the instructions for this kit.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Installation Difficulty of Curt Trailer Hitch 15409 for 2006 Dodge Ram 2500 With Factory Hitch
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: 7-Way Recommendation for a 2001 Dodge Durango with Factory Wiring
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: How Do You Determine If a 2006 Jeep Liberty Has the Tow Package Wiring?
- Q&A: How to Install a 7-Way Connector on a 2001 Dodge Ram 1500
- Q&A: Approximate Cost for Weld-On Hitch Installation By Professional Certified Welder
- Q&A: Hitch Pin Weight Capacity and Sheer Strength