Can Beam Bracket 59149 Be Used to Make a Tailgate on a Trailer
Question:
I have two rows of horizontal e-tracks running down the deck of my trailer. I have some at the very edge. There is no tailgate for this trailer. Can I use it to secure a beam socket horizontally as a tailgate? Its not an orientation I have seen demonstrated before. PS. I am aware that they arent properly lined up in the picture. That has already been fixed.
asked by: Anna
Helpful Expert Reply:
In order to accomplish what you want to do there isn't a better product than the E-Track Wood Beam Socket # 59149. Of course you would need two of them. You wouldn't want to make the tailgate too tall either since it would only be supported at the floor of the trailer.
Product Page this Question was Asked From
E Track Wood Beam Socket for Standard 2" Lumber - Qty 1
- E-Track
- E-Track Cargo Organizers
- Board Holder
- Erickson
more information >
Continue Researching
- Article: Trailer Maintenance Schedule
- Q&A: Placement of Front and Rear Hangers When Building a Tandem Axle Trailer
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: Replacement Hub, Bearings, Races, and Seals for Trailer Hub with H-1377 Bearing
- Q&A: Replacement Hub for a UFP H-1377 on a 2004 Tahoe Boat Trailer
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Trailer Wiring Diagrams
- Q&A: E-Track Recommendations for Making a Queen Size Bed on Inside of Enclosed Trailer
- Article: How to Measure a Trailer Axle
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Q&A: Spare Tire Carrier Recommendation for Trailer with Angle Iron Frame
- Article: How to Install E-Track in 3 Easy Steps
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Bleed Your Trailer Surge Brakes