Design of EZ-Lube Spindles to Allow Grease to Reach Inner and Outer Bearings
Question:
My axle is 1inch and has holes at the top and bottom of the inner bearing. Is there a hole going all the way through the axle to the inner bearings?
asked by: Lester M
Expert Reply:
I think you may be referring to the spindle that is installed on your trailer axle. The spindle is the part such as # TRU74FR which has a grease zerk fitting on the spindle's end. This grease fitting allows you to fill the hub bore and both inner and outer bearings with grease without having to remove the hub to pack the bearings by hand.
If you have this type of EZ-Lube spindle you do not also need to use Bearing Buddy bearing protectors like those mentioned in the question you reviewed. One or the other will be used in any given application.
An EZ-Lube spindle like the one mentioned will have a hole toward the inside of the spindle, the end closer to the trailer, right near where the grease seal rides. Please refer to the linked photo.
Product Page this Question was Asked From
#84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axle - 1-3/4" Diameter
- Trailer Spindles
- EZ Lube Spindle
- 1-3/4 Inch Diameter
- Round
- For 3500 lb Axle
- TruRyde
more information >
Continue Researching
- Search Results: washer
- Search Results: 84 spindle
- Search Results: l44649
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles
- Shop: CE Smith Trailer Hub Assembly w/ Carrying Case for 3,500-lb Axles - 5 on 4-1/2 - Pre-Greased
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: #84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axle - 1-3/4" Diameter
- Search Results: zerk
- Video: Demco Trailer Brakes DM60124 Review
- Q&A: Are D-Washers and Tang Washers Both Necessary on Trailer Spindle
- Q&A: Grease Zerk Fitting Replacement vs. Spindle Replacement
- Q&A: Does Tang Washer Go Between Spindle Nut and Hub Washer
- Shop: #84 E-Z Lube Spindle w/ Brake Flange for 3,500-lb Trailer Axles - 4" Drop
- Shop: Timken Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Washer For 1" Spindle
- Q&A: How to Find the Spindle Number on a Trailer Axle
- Q&A: Greasing Trailer Axle Spindle Where Zerk Fitting Broke Off
- Q&A: Replacement Grease Zerk for EZ Lube Spindle
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: red grease
- Search Results: leaf springs
- Search Results: ez lube spindle