When Installing Optronics Streamline Stop/Turn Light # STL79RB Which Blinker Circuit Should be Used
Question:
I would like to hook up the STL79RB on the rear of the very top of the cargo trailer in the middle I understand that the white wire goes to ground and the black wire goes to running lights and the red wire is supposed to go to Brake/turn signal wire but which one ...my question is does it go to the left hand signal wire or right hand signal wire and if so will this light flash when the signal switch is actviated? or since i have a 7 wire system/plug should i hook the red wire of my STL79RB to the Brakeinch wire electric brake wire Please send diagram
asked by: Meadow H
Expert Reply:
Ideally you use two of the Sealed, Streamline LED Trailer Stop, Turn and Tail Lights # STL79RB. One for each side of the trailer. They can be installed right next to each other. Like this you'd be able to use the appropriate blinker circuit for the side of the trailer that way they will act as a turn signal and brake light and will flash and illuminate as needed.
Product Page this Question was Asked From
Optronics Streamline LED Trailer Tail Light - Submersible - 3 Function - 11 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 17L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: Optronics Streamline LED Trailer Tail Light - Submersible - 3 Function - 11 Diodes - Red Lens
- Shop: Optronics Streamline LED Combination Trailer Tail Light - Submersible - 11 Diodes - Clear Lens
- Q&A: Does the Optronics Sealed Streamline LED Trailer Tail Light Include Mounting Hardware
- Article: Trailer Wiring Diagrams
- Q&A: Is Light Kit Needed for Covered Bike Rack at Rear of Fifth Wheel Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Bearings and Seals for Curt 5.2K to 8K Axle
- Q&A: Replacement Trailer Grease Seal for an NOK AD2527E Seal on a Boat Mate Trailer
- Q&A: Could Safety Chains for Ranch Hitch Coupler Adapter item # AM3109 Fit Gooseneck
- Q&A: Could Ranch Hitch Gooseneck Adapter Safety Chains Fit Gooseneck Hitch
- Q&A: Installation of B&W Extend-A-Goose Gooseneck Coupler
- Article: Carrying Bikes While Towing a 5th Wheel Camper Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Most Popular Wheel Bearings
- Article: Where to Position the Trailer Axle?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)