Compatibility of the Stake Pocket Tie-Down Anchor Part # WFSPDR
Question:
The stake pockets on my car hauler measure 5x1.75inch inside. Im certain these will work but would like your opinion.
asked by: Tyler
Expert Reply:
The Stake Pocket Tie-Down Anchor part # WFSPDR is designed to fit in a standard 2x4 stake pocket opening which actually measures to be around 3-1/2" long x 1-1/2" wide inside to inside. If the "5x1.75inch" you provided is formatted length x width then this tie-down would not be a good fit for you and I recommend adding part # C83072 in order to accommodate it.
I have attached a review video of the above tie-down for you. The dimensions for the tie-down can be found on the product page.
Products Referenced in This Question
Curt Stake Pocket for Flatbed Trucks or Trailers - Weld On - Qty 1
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Stake Pockets
- 2 x 4 Stake Pocket
- CURT
more information >
Product Page this Question was Asked From
Stake Pocket Tie-Down Anchor - Black Powder Coat - 2-1/4" D-Ring - 4,000 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Stake Pockets
- 4000 lbs
- Stake Pocket Anchor
- Redline
more information >
Continue Researching
- Q&A: Do 2x4s Get Attached Into the Stake Pocket # C83072
- Shop: Stake Pocket Tie-Down Anchor - Black Powder Coat - 2-1/4" D-Ring - 4,000 lbs
- Search Results: stake pocket mount
- Q&A: Lug Nut Torque Recommendation for Dexter Hub # 8-219-4UC3-EZ to 17.5 inch Wheel
- Q&A: Lug Nut Torque to Use with 15 inch Trailer Wheel
- Shop: Bright Way Smart Charger and Maintainer - 12V - 7.5 Amp
- Shop: 2.5-Watt Solar Battery Charger
- Search Results: clevis slip hook
- Article: How to Charge a Dump Trailer Battery
- Shop: Trailer Hitch
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: 44649
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Search Results: 68149
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Video: Choosing the Right Brake Controller
- Video: Titan Trailer Brakes T2385200 Review
- Shop: Brake Controller
- Shop: Grease Seals 10-36 (pair)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: 25580
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Search Results: dust cap
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)